Codec C90
Contents | Introduction |
| GetGettinging startstarted |
|
|
|
|
About main and dual monitors
The main monitor
The main monitor can be connected to the default video output HDMI 1 or one of the other outputs which are HDMI 3,
Connecting to HDMI 1
When you connect the main monitor to the default video output on Codec C90 the menu, icons and other information on screen (OSD - on screen display) will show on this monitor.
Connecting to DVI-I 2, DVI-I 4, HDMI 3
When connecting the main monitor to another video output, and no menu shows on screen, you must run a shortcut on the remote control to reset the resolution and move the OSD to this output.
The resolution will be set to the default value, which is 1280x720@60Hz for HDMI and 1024x768@60Hz for DVI.
The menu on screen, icons and other information (OSD - on screen display) will be moved to the selected output.
Key sequence
If connected to
•Disconnect * # * # 0 x # (where x is output 2, 3 or 4)
Example: Set
•Disconnect * # * # 0 2 #
You can also set the resolution and the OSD output by setting up a serial port connection and run API commands. See the Codec C90 System Integrator Guide for information about API commands.
Administrator Guide
About the menus | About the settings | Settings Library | Cameras | Appendices | Contact us |
The video outputs at Codec C90
HDMI 3
(the default connector for the dual monitor)
HDMI 1
(the default connector for the main monitor)
Dual monitors
When you want to run a dual monitor setup, connect the second monitor to video output HDMI 3 on Codec C90.
Dual monitor configuration
Go to Administrator settings to set the monitor to dual:
1.Navigate to Settings > Administrator Settings > Video > Output > Monitor
2.Set the Monitor to Dual.
3.Press Home ( 
) to exit.
13 |