Runco VX-44D, VX-55D operation manual Memory Presets

Page 80

Operation

Memory Presets ➤

Memory Presets

➡ISF Night ISF Day

Custom Save Reset

THX

Save

Reset

For each input, the DHD Controller lets you save image quality settings as presets that you can recall at a later time. You can create up to four presets per input and display mode (resolution and frame rate).

The DHD Controller stores the following display modes in each memory preset:

•480i

•480p

•576i

•576p

•720p/24 Hz

•720p/25 Hz

•720p/30 Hz

•720p/50 Hz

•720p/60 Hz

•1080i/50 Hz

•1080i/50 Hz (Australia)

•1080i/60 Hz

•1080p/24 Hz

•1080p/25 Hz

•1080p/30 Hz

•1080p/50 Hz

•1080p/60 Hz

Use the Memory Presets menu to recall saved image presets, or to save image settings in the “Custom” or “THX” memory location. The currently-selected preset is indicated by a “➡” to its left; in the example shown here, ISF Night is selected.

You should save changes to any of the following settings to a preset; otherwise they will be lost when a new input source or resolution is selected:

•Brightness

•Contrast

•Color saturation

•Tint

•Sharpness

•Gamma

•Lamp Settings

•Color temperature and white balance

To select a memory preset, press or to highlight it and press ENTER.

To save the settings for the current input and display mode to the Custom or THX memory preset, select it, press or to highlight Save and press ENTER.

To save the settings for the current input and display mode to the

Note ISF Night or ISF Day memory preset, select Save ISF Night or Save ISF Day from the Calibration menu (refer to Save ISF Night/Save ISF Day on page 69).

64

Runco VX-44d/-55d Installation/Operation Manual

Page 79 Page 81
Image 80
Page 79 Page 81
Contents VX-44d VX-55d Page RuncoCare Standard Two Year Limited Warranty RuncoCare Standard FeaturesRuncoCare Claim Procedure Page Copyright and Trademarks Important Safety Instructions Compliance Information Declaration of ConformityFCC Part Page Table of Contents Install Projector Stand CineWide with AutoScope, Floor-Mount Maintenance and Troubleshooting SpecificationsOperation External ControlTable of Contents Xiv List of Figures Xvi Introduction About This ManualUsing This Manual Certain featuresSignificance. They also provide supplemental information Degrade performance or cause a malfunctionDescription, Features and Benefits Format screenOptional Accessories Controls and Functions VX-44d/-55d at a GlanceVX-44d/-55d Input Panel Input 1 Rgbhv RemoteEthernet VX-44d/-55d Built-In Keypad UP Button Left ButtonDown Button Right ButtonDHD Controller Front Panel Runco IconIR Sensor Vacuum Fluorescent DisplayMenu Button Standby LEDDHD Controller Rear Panel Outputs 1. Hdmi OutDisplay Control TriggersMain AC Fuse Main Power SwitchInputs VX-44d/-55d Remote Control Unit DHD Controller/VX-44d/-55d Remote ControlIR Output Indicator EnterReturn / Exit LightCinema ISF NightISF DAY CustInstallation Remote ControlQuick Setup Installation OverviewInstallation must be performed by a qualified custom video Installation specialistInstallation Considerations Projector Installation OptionsInstallation Type Ambient LightVX-44d/-55d Lens Options and Throw Ratios Ceiling Installation Floor InstallationVertical and Horizontal PositionHorizontal Lens Shift Example only Vertical and Horizontal Lens Shift Limits Synchronization Issues Possible Audio Latency for Various Input/Output TimingsAudio/Video Input Timing Possible Audio Latency millisecondsInstalling the Projection Lens Other ConsiderationsFixed CineWide Are both fully assembled Installing the Optional CineWide Lens MountAutoScope or Base Plate AutoScope stand used for floor-mounted projector Mounting VX-44d/-55dConnections to VX-44d/-55d and DHD Controller VX-44d/VX-55d Input PanelConnecting Source Components to the DHDSections that follow Controller10. Hdmi Source Connections BD/DVD DTV-STB DTV-Set-Top BoxComputer RGB Camcorder 12. Rgbhv Source ConnectionsGaming Console VCRDVD/DTV STB Composite and S-Video Source Connections CamcorderRS-232 Controller ConnectionConnecting 12-volt Trigger Outputs to External Equipment AutoScope Lens MotorConnecting an External IR Receiver to the DHDConnecting to AC Power Input voltage to the AutoScope lens motor must be betweenTurning on the Power HdmiPrimary Lens Adjustments Adjusting the Picture OrientationOn the VX-44d/-55d built-in keypad see -3, press Menu Focus and Zoom Vertical and Horizontal Lens ShiftInstalling and Adjusting the CineWide Anamorphic Lens Assembly to Lens MotorCarriage Plate CineWide With AutoScope or BaseHorizontal Position X Adjustment Installation Anamorphic Lens Top View GeometryInstallation Lamp Adjust Are disabledOptimizing Lamp and Lens Performance Navigating the Projector MenusLumaCal lamp calibration takes approximately two minutes To using LumaCalInstallation Menu Power cycles Above, the Automatic Lens Calibration setting has no effectFilter Replacement on Working With the LampMore information, refer to Lamp on More information, refer to RVR onOriginally expected may no longer be possible Intensity value is not the actual lumen output, but rather aMore easily maintained as the lamp ages Installation Using the On-Screen Menus OperationRunco Video ServiceMain Menu Input Source Aspect RatioInput Source Aspect RatioAspect Ratio Settings Remote Aspect Ratio Control Description Key 169Select 169 to view 169 DVDs Hdtv programs in theirRemote Aspect Ratio Control Description Key OverscanPicture PictureTypical Gray Bar Pattern for Adjusting Contrast Gray Yellow Cyan Green Magenta Red Blue Typical Test Pattern for Adjusting Sharpness Input Position ResolutionInput Position Adjust the Phase after adjusting Tracking see below Memory Presets Memory PresetsCalibration You must enter a passcode to access the Calibration menuInformation Operation Color Temperature Presets and Associated Color Points Color Temperature Preset Associated x/y ValuesAuto Color Enable Test Pattern Enable Description Setting Display ColorCopied settings are not retained after a power cycle Copy/PasteService You must enter a passcode to access the Service menuService Should be used by ISF-certified technicians onlyInput Names Absolutely necessary, as it may cause artifacts in the image Operation Operation Operation 64 and ISF Day/Night Memory Presets Lamp Replacement Maintenance and TroubleshootingLamp and Filter Replacement Removing the Lamp Lens Replacement Removing the Primary Lens Symptom Possible Causes Solution Troubleshooting TipsTroubleshooting Chart Configure Lens Motor VX-44d/-55d Error Codes Error CodesCode Description General Lamp FailuresBuilt-In Keypad Code Description Power and CoolingTipm Image Processor Code Description Panel Driver and Formatter MiscellaneousMaintenance and Troubleshooting Port Configuration Serial Command SyntaxExternal Control Serial CommunicationsAspect Ratio Commands Serial CommandsInput Selection Commands Image Preset Commands Output Shift Commands Enter key Exit Return keyWith Toggle Bit = Hex Binary Function Start Using Discrete IR CodesCommand Bits IR Command List Remote Control With Toggle Description Button Name Bit =RC5 Control Codes for the DHD Controller RC5 DataEnter VX-44d/-55d Specifications SpecificationsVX-44d/-55d Specifications Theater Calibration Specifications Industry-Standard SpecificationsPower Requirements VX-44d DimensionsDHD Controller Specifications DHD Controller SpecificationsVX-44d/-55d Dimensions VX-44d/-55d DimensionsSupported Signal Timings by Input Format Resolution Frequency Rate Hz MHz KHzSupported Timings Supported? √ = Yes, = NoPAL-B/G/H/I 101 102 Page 020-0826-02 Rev. B April
Related manuals
Manual 114 pages 2.55 Kb

VX-55D, VX-44D specifications

The Runco VX-55D and VX-44D projectors represent a pinnacle in home theater technology, offering expansive image quality and immersive viewing experiences. Runco, known for its commitment to delivering exceptional visual performance, has integrated numerous features and advanced technologies in these models.

One of the standout features of both the VX-55D and VX-44D is their native 1080p resolution, delivering stunningly sharp images with vibrant colors that capture the finest details. This high definition capability ensures that viewers can enjoy their favorite movies, sports, and gaming content with unparalleled clarity. The projectors utilize the latest DLP (Digital Light Processing) technology, which enhances brightness and color accuracy, providing a more vivid and lifelike picture.

Another impressive characteristic of the Runco VX series is its exceptional contrast ratios. With deep blacks and brilliant whites, these projectors offer a dynamic range that brings out subtle details in both shadow and highlight areas. This contrast performance is particularly beneficial for watching films in darker environments, where the depth of imagery is crucial for immersion.

In terms of color processing, the VX-55D and VX-44D incorporate Runco's proprietary ColorPalette technology. This system ensures accurate and rich color reproduction by utilizing a wide color gamut, allowing viewers to experience content as the creators intended. Coupled with advanced color management capabilities, users can further tweak their viewing experience to match their preferences.

The integration of flexible installation options is another highlight of these projectors. They support up to 10-point digital keystone correction, making setup simple and adaptable to various room configurations. This flexibility ensures that no matter the space, users can achieve a perfectly aligned and geometrically accurate image.

Runco has also designed the VX-55D and VX-44D with user-friendly interfaces, including intuitive remote controls and on-screen menus. Both projectors come equipped with multiple HDMI inputs, allowing users to connect various devices seamlessly. Additionally, they support 3D content playback, a feature that has become increasingly important for enhancing the cinematic experience.

Energy efficiency is a consideration in the design of these projectors as well, making them not only high-performance devices but also more sustainable than many of their counterparts. With a sleek aesthetic, the Runco VX-55D and VX-44D can seamlessly blend into any home theater setup, adding a touch of elegance while providing an extraordinary viewing experience.

In summary, the Runco VX-55D and VX-44D projectors are characterized by their high-definition resolution, advanced DLP technology, rich color processing, and flexible installation options, making them ideal choices for any home theater enthusiast looking to elevate their viewing experience.
Top Page Image Contents