Runco 1080p manual PDig, IDig, 4x3 nt, Lbx nt, VW nt, Cin nt, VC nt

Installation

All available channels are listed in the Channel Setup menu (Figure 3-17),which describes how each channel can be accessed and which serves as the gateway for editing, copying and deleting channels.

01	0,2	pDig	720p from DHD
02	0,2	iDig	1080i16x9 nt
03	0,2	iDig	1080i	4x3 nt
04	0,2	iDig	1080i	Lbx nt
05	0,2	iDig	1080i	VW nt
06	0,2	iDig	1080i	Cin nt
07	0,2	iDig	1080i	VC nt
08	0,2	pDig	1080p16x9 nt
09	0,2	pDig	1080p 4x3 nt

Figure 3-17. Channel Setup Menu

To display the Channel Setup menu, press 3 or highlight Channel Setup and press

ENTER or . The Channel Setup menu appears with the active channel highlighted.

WHAT APPEARS IN THE CHANNEL SETUP MENU? This menu lists all channels defined so far and indicates where they are connected on the input panel.

The far left column lists channel numbers currently defined. The values in the far right columns indicate horizontal and

vertical frequencies — if someone has defined a name for this channel, it appears here instead. Remaining columns contain details pertaining to each channel setup, such as its switcher

number (always 0 = projector), slot location, a variety of icons indicating access to each channel, and an abbreviated description of each signal type.

Signal Type Abbreviations: The Channel Setup menu identifies signal types in a shortened form. These descriptors indicate what signal information the projector uses to identify a match for a given channel, and are preceded by either an “i” (for interlaced signals) or “p” (for progressive signals).

When used with the DHD Controller, the HDMI output signal is either “pDig” or “iDig.”

Unlocking Channels: Channels are pre-configured at the Runco factory for use with the DHD Controller, and are locked to prevent the factory settings from being over-written accidentally. For 1080i and 1080p digital signals, there are separate channels for each aspect ratio and “ISF” memory preset (day and night).

Before proceeding with calibration, unlock the currently-active channel so that any changes you make are stored in that channel.

To unlock a channel:

1.Select Channel Setup from the Main Menu to display the Channel Setup menu.

2.The active channel should be highlighted. Press ENTER to go to the Channel Edit submenu.

48 Runco VX-44d/-55d Owner’s Operating Manual