Alloy Computer Products RNS5, RNS8 user manual Mounting Installation, DIN-Rail Mounting

Page 12

Mounting Installation

DIN-Rail Mounting

The DIN-Rail clip is already attached to the RNS5/8 when packaged. If the DIN-Rail clip is not screwed on the RNS5/8, follow the instructions and the figure below to attach the DIN-Rail clip to the RNS5/8.

Rear Panel of the RNS5/8

DIN-Rail Clip

1.Use the screws to attach the DIN-Rail clip to the rear panel of the RNS5/8.

2.To remove the DIN-Rail clip, reverse step 1.

Image 12

Contents Industrial 5-port/8-port Ethernet Rail Switch User’s ManualContent Features IntroductionPackage Checklist Dimensions Hardware DescriptionFront Panel 54mm x 135mm x 105mmPage Wiring the DC Power Inputs Bottom ViewLED Indicators Status DescriptionLNK/ACT of Port FDX/COL of PortPort LED Status Description Port Status PortTo Port LNK/ACT of Port 7/8Ports FDX/COL of Port 7/8Pin MDI-X Signals MDI Signals CablingMounting Installation DIN-Rail MountingPage Wall Mounting Hardware Installation Installation and TestingPage Page Page Trouble shooting Standards ProtocolsTechnology TransmissionPower Supply PowerInstallation TemperatureIEC60068-2-6 Vibration