AMD GA-MA69VM-S2 user manual Raid

(2) Configuring SATA controller mode and boot sequence in BIOS Setup

You have to make sure whether the SATA controller is configured correctly in system BIOS Setup and set BIOS boot sequence for the SATA hard drive(s)/RAID array.

Step 1:

Turn on your computer and press Del to enter BIOS Setup during POST (Power-On Self Test). In BIOS Setup, go to Integrated Periperals. Ensure that OnChip SATA Controller is enabled. If you wish to create RAID array, set OnChip SATA Type to RAID. (Figure 1).

		CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
			Integrated Peripherals		Item Help
					Menu Level`
`	IDE Configuration		[Press Enter]		Item Help
	OnChip SATA Controller		[Enabled]		Menu Level`
	OnChip SATA Type		[RAID]
	Onboard Audio Function		[Auto]
	Onboard LAN Function		[Enabld]
	Onboard LAN Boot ROM		[Disabled]
	OnChip USB Controller		[Enabled]
	USB EHCI Controller		[Enabled]
	USB Keyboard Support		[Enabled]
	USB Mouse Support		[Disabled]
	Legacy USB storage detect		[Enabled]
	Onboard Serial Port 1		[3F8/IRQ4]
	Onboard Serial Port 2		[2F8/IRQ3]
	Onboard Parallel Port		[378/IRQ7]
	Parallel Port Mode		[SPP]
x ECP Mode Use DMA			3
KLJI: Move		Enter: Select	+/-/PU/PD: Value	F10: Save	ESC: Exit	F1: General Help
	F5: Previous Values		F6: Fail-Safe Defaults		F7: Optimized Defaults

Figure 1

The BIOS Setup menus described in this section may not show the exact settings for your motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you have and the BIOS version.

- 59 - Appendix

English