AMX IR instruction manual Installation method B, Installation Method a

Page 19

Wiring and Installation

FIG. 20 Installation Method A

Two #6 nylon screw anchors and two #6 x 1-inch long screws are provided with each unit.

Installation method B

Use when installing a swivel-mount unit using the provided mounting bracket.

FIG. 21 Installation method B

!On drywall, install using the included wall anchors. Use a 3/16-inch drill bit.

!On wood, install using the included #6 mounting screws.

1.If you are installing the IRX-SM+, remove the housing and wire the unit to the AMX IR receiver as shown in Wiring.

2.If you are installing the AXR-IRSM+, remove the housing and locate the AXlink connector.

IR Sensors and Receivers	15

Image 19

Contents IR Sensors Receivers AMX Limited Warranty and Disclaimer Table of Contents Table of Contents Product Information FeaturesAXD-IR+ Specifications Specifications Sensors and ReceiversIRX-DM+ Specifications AXR-IRSM+ SpecificationsApplications IRX-SM+ SpecificationsAXR-IRSM+ Product Information Setting the Receive Frequency Wiring and InstallationSetting the AXlink Device Number Configuring the ReceiversReceiver IR validation level Setting the IR Validation LevelSensor IR validation level Preparing captive wires Wiring the IR Sensors and ReceiversWiring guidelines Wiring Specifications Connecting the WiringWiring the AXD-IR+ or the AXR-IRSM+ to AXlink Checking IR Data status Wiring the IRX-DM+ or IRX-SM+ to the AMX IR ReceiverChecking AXlink status Mounting the UniMount Sensor or Receiver AXD-IR+ and IRX-DM+ 1-gang cutout dimensionsMounting the Swivel-Mount Sensor or Receiver Installation method aInstallation Method a Installation method BWiring and Installation Wiring and Installation IR Sensors and Receivers AMX reserves