D-Link DGS-1024, DGS-1016 manual Mounting the Switch on a Rack, Mounting the Switch to a Rack

D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch

•The power outlet should be within 1.82 meters (6 feet) of the Switch.

•Visually inspect the power cord and see that it is fully secured to the AC power port.

•Make sure that there is adequate space for proper heat dissipation from and adequate ventilation around the Switch. Leave at least 10 cm (4 inches) of space at the front and rear of the Switch for ventilation.

•Install the Switch in a fairly cool and dry place for the acceptable temperature and humidity operating ranges.

•Install the Switch in a site free from strong electromagnetic field generators (such as motors), vibration, dust, and direct exposure to sunlight.

•When installing the Switch on a level surface, attach the rubber feet to the bottom of the device. The rubber feet cushion the Switch, protect the casing from scratches and prevent it from scratching other surfaces.

Mounting the Switch on a Rack

The DGS-1016D/1024D can easily be mounted on a rack. Two mounting ears are provided for this purpose. Make sure that the front panel is exposed in order to view the LEDs. Please refer to the following illustrations:

Figure 2-1. Mounting the Switch to a Rack

9