D-Link DGS-1016, DGS-1024 manual Section, Switch To End Node

Page 21

D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch

Section 3

Connecting The Switch

Switch To End Node

Switch To Hub or Switch

Connecting To a Server

NOTE: All 16/24 high-performance NWay Ethernet ports can support both MDI-II and MDI-X connections.

Switch To End Node

End nodes include PCs outfitted with a 10, 100 or 1000 Mbps RJ-45 Ethernet/Fast Ethernet Network Interface Card (NIC) and most routers.

An end node can be connected to the Switch via a twisted-pair Category 3, 4, or 5 UTP/STP cable. The end node can be connected to any of the ports of the Switch.

Figure 3-1. Switch connected to an end node

12

Image 21

Contents Manual Warnung Contents Intended Readers PrefaceSafety Cautions Safety InstructionsSafety Instructions General Precautions for Rack Mountable Products Safety Instructions Protecting Against Electrostatic Discharge Ethernet Technology Fast Ethernet TechnologyGigabit Ethernet Technology Switching Technology Features Switch DescriptionLink DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Front-Panel Components LED IndicatorsPower Indicator Cable connection good − Speed LED Green − Link/Act Rear Panel DescriptionBefore You Connect to the Network Package ContentsMounting the Switch to a Rack Mounting the Switch on a RackProvide for Adequate Ventilation Attaching the Rubber FeetPower Failure Power OnSection Switch To End NodeSwitch to Hub or Switch Connection to a Server Connecting To Network Backbone or ServerAppendix a Physical and Environmental Glossary Line speed See baud rate Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Wichtige Sicherheitshinweise Warranties Exclusive Limited Warranty Hardware Software Warranty and Registration Information USA Only Page Page Page Page Norway International OfficesTurkey Registration Card