D-Link DGS-1024, DGS-1016 manual Power On, Power Failure

Page 20

D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch

Power On

Plug one end of the AC to DC power converter into the power connector of the Switch and the other end into the local power source outlet.

After the Switch is powered on, the LED indicators will momentarily blink. This blinking of the LED indicators represents a reset of the system.

Power Failure

As a precaution, in the event of a power failure, unplug the Switch. When power is resumed, plug the Switch back in.

11

Image 20

Contents Manual Warnung Contents Preface Intended ReadersSafety Instructions Safety CautionsSafety Instructions General Precautions for Rack Mountable Products Safety Instructions Protecting Against Electrostatic Discharge Gigabit Ethernet Technology Ethernet TechnologyFast Ethernet Technology Switching Technology Switch Description FeaturesLink DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch LED Indicators Front-Panel ComponentsPower Indicator Rear Panel Description Cable connection good − Speed LED Green − Link/ActPackage Contents Before You Connect to the NetworkMounting the Switch on a Rack Mounting the Switch to a RackAttaching the Rubber Feet Provide for Adequate VentilationPower On Power FailureSwitch To End Node SectionSwitch to Hub or Switch Connecting To Network Backbone or Server Connection to a ServerAppendix a Physical and Environmental Glossary Line speed See baud rate Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Wichtige Sicherheitshinweise Warranties Exclusive Limited Warranty Hardware Software Warranty and Registration Information USA Only Page Page Page Page International Offices NorwayTurkey Registration Card