D-Link DGS-1016, DGS-1024 manual Connecting To Network Backbone or Server, Connection to a Server

Page 23

D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch

Connecting To Network Backbone or Server

Any of the 16/24 Gigabit Ethernet ports is ideal for uplinking to a network backbone or network server. These ports operate at 1000 Mbps in full- duplex mode.

Figure 3-3. Connection to a Server

14

Image 23

Contents Manual Warnung Contents Intended Readers PrefaceSafety Cautions Safety InstructionsSafety Instructions General Precautions for Rack Mountable Products Safety Instructions Protecting Against Electrostatic Discharge Gigabit Ethernet Technology Ethernet TechnologyFast Ethernet Technology Switching Technology Features Switch DescriptionLink DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Front-Panel Components LED IndicatorsPower Indicator Cable connection good − Speed LED Green − Link/Act Rear Panel DescriptionBefore You Connect to the Network Package ContentsMounting the Switch to a Rack Mounting the Switch on a RackProvide for Adequate Ventilation Attaching the Rubber FeetPower Failure Power OnSection Switch To End NodeSwitch to Hub or Switch Connection to a Server Connecting To Network Backbone or ServerAppendix a Physical and Environmental Glossary Line speed See baud rate Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Wichtige Sicherheitshinweise Warranties Exclusive Limited Warranty Hardware Software Warranty and Registration Information USA Only Page Page Page Page Norway International OfficesTurkey Registration Card