D-Link DGS-1016, DGS-1024 manual

Page 37

WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ANY OTHER WARRANTIES OR REMEDIES, EXPRESS, IMPLIED OR STATUTORY

Governing Law: This Limited Warranty shall be governed by the laws of the State of California. Some states do not allow exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the foregoing limitations and exclusions may not apply. This limited warranty provides specific legal rights and the product owner may also have other rights which vary from state to state.

Trademarks: D-Link is a registered trademark of D-Link Systems, Inc. Other trademarks or registered trademarks are the property of their respective manufacturers or owners.

Copyright Statement: No part of this publication or documentation accompanying this Product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Corporation/D-Link Systems, Inc., as stipulated by the United States Copyright Act of 1976. Contents are subject to change without prior notice. Copyright© 2004 by D-Link Corporation/D-Link Systems, Inc. All rights reserved.

CE Mark Warning: This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

FCC Statement: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

For detailed warranty outside the United States, please contact corresponding local D-Link office.

Register online your D-Link product at http://support.dlink.com/register/

28

Image 37
Contents Manual Warnung Contents Intended Readers PrefaceSafety Cautions Safety InstructionsSafety Instructions General Precautions for Rack Mountable Products Safety Instructions Protecting Against Electrostatic Discharge Fast Ethernet Technology Ethernet TechnologyGigabit Ethernet Technology Switching Technology Features Switch DescriptionLink DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Front-Panel Components LED IndicatorsPower Indicator Cable connection good − Speed LED Green − Link/Act Rear Panel DescriptionBefore You Connect to the Network Package ContentsMounting the Switch to a Rack Mounting the Switch on a RackProvide for Adequate Ventilation Attaching the Rubber FeetPower Failure Power OnSection Switch To End NodeSwitch to Hub or Switch Connection to a Server Connecting To Network Backbone or ServerAppendix a Physical and Environmental Glossary Line speed See baud rate Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Wichtige Sicherheitshinweise Warranties Exclusive Limited Warranty Hardware Software Warranty and Registration Information USA Only Page Page Page Page Norway International OfficesTurkey Registration Card