D-Link DGS-1024D, DGS-1016D manual Power Input on Rear Panel, Rear panel view of the Switch

Page 18

Power Input on Rear Panel

The power cable connection is located on the rear panel of the Switch.

Rear panel view of the Switch

Switch power input is provided by and internal universal power supply (100-240VAC : 12V/3.3A).

The AC power connector is a standard three-pronged connector that supports the power cord. Please see the Power On section below for instructions on how to properly connect the Switch to a power source.

Image 18

Contents 16/24-Port 10/100/1000Mbps Gigabit Ethernet Switch ManualLink DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Contents Preface Safety Instructions Safety CautionsPage General Precautions for Rack Mountable Products Safety Instructions Protecting Against Electrostatic Discharge Switch Description SectionSwitch Features Gigabit Ethernet Technology 802.1P and QoSAdvantages of QoS Mapping QoS on the Switch Understanding QoSPage LED Indicators LED IndicatorsFront Panel View of the Switch Front-Panel ComponentsCable Diagnostic Link/Act LED Indicator Description PowerCable Diagnostic 100Mbps/1000MbpsPower Input on Rear Panel Rear panel view of the SwitchInstallation Package ContentsBefore You Connect to the Network Mounting the Switch on a Rack Mounting the Switch to a RackAttaching the Rubber Feet Provide for Adequate VentilationAttaching the Rubber Feet Power On Power FailureSection Cable QualitySwitch to End Node Switch connected to an end nodeSwitch to Hub or Switch Connect to another switch or hubConnecting to Network Backbone or Server Connection to a ServerAppendix GeneralPhysical and Environmental Performance Glossary Line speed See baud rate Page USA Warranty and Registration Information Page Page Page Page Page International Offices Belgium SpainHungary