D-Link DGS-1016D, DGS-1024D manual Power On, Power Failure

Page 23

Power On

To power on the Switch, Plug-in the female connector of the provided power cord into this socket, and the male side of the cord into a suitable power source.

After the Switch is powered on, the LED indicators will blink briefly while the system resets.

Power Failure

As a precaution, in the event of a power failure, unplug the Switch. When power is resumed, plug the Switch back in.

Image 23

Contents Manual 16/24-Port 10/100/1000Mbps Gigabit Ethernet SwitchLink DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Contents Preface Safety Cautions Safety InstructionsPage General Precautions for Rack Mountable Products Safety Instructions Protecting Against Electrostatic Discharge Section Switch DescriptionSwitch Features Advantages of QoS Gigabit Ethernet Technology802.1P and QoS Understanding QoS Mapping QoS on the SwitchPage Front-Panel Components LED IndicatorsFront Panel View of the Switch LED IndicatorsCable Diagnostic 100Mbps/1000Mbps LED Indicator Description PowerCable Diagnostic Link/ActRear panel view of the Switch Power Input on Rear PanelPackage Contents InstallationBefore You Connect to the Network Mounting the Switch to a Rack Mounting the Switch on a RackAttaching the Rubber Feet Attaching the Rubber FeetProvide for Adequate Ventilation Power Failure Power OnCable Quality SectionSwitch connected to an end node Switch to End NodeConnect to another switch or hub Switch to Hub or SwitchConnection to a Server Connecting to Network Backbone or ServerGeneral AppendixPhysical and Environmental Performance Glossary Line speed See baud rate Page USA Warranty and Registration Information Page Page Page Page Page Belgium Spain International OfficesHungary