D-Link DGS-1016D, DGS-1024D manual General Precautions for Rack Mountable Products

Page 7

D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch

General Precautions for Rack-

Mountable Products

Observe the following precautions for rack stability and safety. Also refer to the rack installation documentation accompanying the system and the rack for specific caution statements and procedures.

Systems are considered to be components in a rack. Thus, "component" refers to any system as well as to various peripherals or supporting hardware.

CAUTION: Installing systems in a rack without the front and side stabilizers installed could cause the rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore, always install the stabilizers before installing components in the rack.

After installing system/components in a rack, never pull more than one component out of the rack on its slide assemblies at one time. The weight of more than one extended component could cause the rack to tip over and may result in serious injury.

Before working on the rack, make sure that the stabilizers are secured to the rack, extended to the floor, and that the full weight of the rack rests on the floor. Install front and side stabilizers on a single rack or front stabilizers for joined multiple racks before working on the rack.

vii

Image 7
Contents Manual 16/24-Port 10/100/1000Mbps Gigabit Ethernet SwitchLink DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Contents Preface Safety Cautions Safety InstructionsPage General Precautions for Rack Mountable Products Safety Instructions Protecting Against Electrostatic Discharge Section Switch DescriptionSwitch Features 802.1P and QoS Gigabit Ethernet TechnologyAdvantages of QoS Understanding QoS Mapping QoS on the SwitchPage Front-Panel Components LED IndicatorsFront Panel View of the Switch LED IndicatorsCable Diagnostic 100Mbps/1000Mbps LED Indicator Description PowerCable Diagnostic Link/ActRear panel view of the Switch Power Input on Rear PanelPackage Contents InstallationBefore You Connect to the Network Mounting the Switch to a Rack Mounting the Switch on a RackProvide for Adequate Ventilation Attaching the Rubber FeetAttaching the Rubber Feet Power Failure Power OnCable Quality SectionSwitch connected to an end node Switch to End NodeConnect to another switch or hub Switch to Hub or SwitchConnection to a Server Connecting to Network Backbone or ServerGeneral AppendixPhysical and Environmental Performance Glossary Line speed See baud rate Page USA Warranty and Registration Information Page Page Page Page Page Belgium Spain International OfficesHungary