D-Link DGS-1016D, DGS-1024D manual Mounting the Switch on a Rack, Mounting the Switch to a Rack

Page 21

Mounting the Switch on a Rack

The DGS-1016D/1024D can easily be mounted on a rack. Two mounting ears are provided for this purpose. Make sure that the front panel is exposed in order to view the LEDs. Please refer to the following illustrations:

Mounting the Switch to a Rack

1.Attach the ears to each side of the Switch, using the screw-holes located on the side of the device.

2.Firmly attach the ears to the rack as shown. Please follow the usual safety precautions for rack-mountable products

Image 21

Contents Manual 16/24-Port 10/100/1000Mbps Gigabit Ethernet SwitchLink DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Contents Preface Safety Cautions Safety InstructionsPage General Precautions for Rack Mountable Products Safety Instructions Protecting Against Electrostatic Discharge Section Switch DescriptionSwitch Features Gigabit Ethernet Technology 802.1P and QoSAdvantages of QoS Understanding QoS Mapping QoS on the SwitchPage Front Panel View of the Switch LED IndicatorsLED Indicators Front-Panel ComponentsCable Diagnostic Cable Diagnostic LED Indicator Description PowerLink/Act 100Mbps/1000MbpsRear panel view of the Switch Power Input on Rear PanelPackage Contents InstallationBefore You Connect to the Network Mounting the Switch to a Rack Mounting the Switch on a RackAttaching the Rubber Feet Provide for Adequate VentilationAttaching the Rubber Feet Power Failure Power OnCable Quality SectionSwitch connected to an end node Switch to End NodeConnect to another switch or hub Switch to Hub or SwitchConnection to a Server Connecting to Network Backbone or ServerGeneral AppendixPhysical and Environmental Performance Glossary Line speed See baud rate Page USA Warranty and Registration Information Page Page Page Page Page Belgium Spain International OfficesHungary