D-Link DES-3216 manual Power On, Rack Installation

Page 14

10/100 Auto Negotiation Switch User’s Guide

2. Install the DES-3216 on the desktop/shelf where you would like to place it.

Rack Installation

The DES-3216 can be mounted in an EIA standard size, 19 inch rack. The dimensions of the DES-3216 are 17.4 x 10.4 x 3.2 inches. The DES-3216 can be placed in a wiring closet along with other equipment.

Follow these steps to install the DES-3216 on a rack:

1.Attach a mounting bracket to each side of the DES-3216 with the screws provided.

2.Slide the DES-3216 into the rack and use the screws provided to secure the DES-3216 to the rack.

3.Connect the power cord and verify that the DES-3216 is receiving adequate power.

Power On

The power supply will adjust to the local power source automatically. The DES-3216 may be plugged in without having any or with all LAN segment cables connected.

The power plug is located at the rear of the DES-3216. Plug the cable into the wall socket and plug the other end into the DES-3216. There is a power on/ off switch located at the rear of the DES-3216. Move the switch to the on position to power the DES-3216 on. The Power LED will light and all ports will auto negotiate the proper speed and duplex mode when the DES-3216 is powered on.

Reboot the DES-3216 if there is a problem. Contact D-Link Systems, Inc. for technical support.

Check the configuration of the DES-3216 after a power failure but do not reset unless it is necessary.

The DES-3216 can be used with power sources in the range 100 to 240 VAC., 50 to 60 Hz.

Installing the DES-3216

6

Image 14

Contents DES-3216 10/100 Auto Negotiation Switch User’s Guide Link Limited Warranty Hardware North, Central, and South America FCC Warning Wichtige Sicherheitshinweise Table of Contents Page Page Organization About This GuideAudience Features IntroductionFront Panel Rear PanelLocal Console Management Management MethodsUpdating Firmware Telnet ManagementDesktop/ Shelf Installation Installing the DES-3216Installation Options Power On Rack InstallationConnecting the DES-3216 to the Network Cable SpecificationsCable Diagram DES-3216 to DES-3216 Connection Connecting the DES-3216 to the DES-5024 and HubsPorts MDI-X PortLQN LEDsPower LED DES-3216 LED PanelLED Managing the DES-3216 Local Console ManagementTelnet ∙ Data bits ∙ Parity None ∙ Stop bits ∙ Flow Control None∙ Default User Name D-Link ∙ Default Password D-Link LogHelp Message Help MessagePanel Conventions SpacebarSpanning Tree Configuration System ConfigurationSwitch Port 1-8, 9-16 Configuration Console ProgramTrunking Port Management Snmp Management ConfigurationVlan Port Management Factory Reset to Default Config Values System Configuration MenuSystem Reset System InformationSystem Information Menu Software UpdateBoot Prom Firmware Version Hardware RevisionMAC Address LAN Default GatewaySoftware Version System DescriptionSystem Reset System ResetFactory Reset Factory ResetFactory Reset Confirmation Disadvantages of Store and Forward System Rate ControlAdvantages of Store and Forward Advantages of Cut-Through Disadvantages of Cut-ThroughSoftware Update Menu Software UpdateSoftware Update Transfer File Transfer through Xmodem Create New User User Account ManagementUser Account Change Menu Access Level PasswordConfirm Password User NameDelete Delete UsersStatus Change Password Change PasswordOld Password New PasswordSwitch Port Configuration Physical Switch Port Configuration MenuState Port State PrioritySTA Operation Levels Spanning Tree ConfigurationSpanning Tree Configuration Menu Spanning Tree AlgorithmRoot Cost Forward Delay TimeBridge Priority Hello TimeRoot Port User Selective STA parametersSnmp Management Configuration Snmp Management Configuration MenuSnmp Community String Snmp Manager SettingAccess Right Cold Start Snmp Trap Manager SettingAuthentication Failure Link Change EventPage Vlan Port Management Vlan Port Management MenuVlan Port Management menu Port # Create New VlanNew Vlan Name TrunkGroupDelete Vlan Menu Vlan NameModify Vlan Menu Virtual LAN NameTrunking Port Management Menu Trunking Port Management menuName Create New Trunking PortNew Trunking Group Name Delete Trunking Port Trunking PortModify Trunking Port Trunking Port NameTroubleshooting Problem SolutionPage Port Specifications Appendix a DES-3216 Technical SpecificationsSwitch Specifications 10/100 Auto Negotiation Switch Users’ Guide General EMI 10/100 Auto Negotiation Switch Users’ Guide Performance Access Level IndexUser Name 32, 33