D-Link DES-3216 manual

Page 64

10/100 Auto Negotiation Switch Users’ Guide

and power is being received though the wall socket, the power supply is not working. Return the unit.

All LEDs are Off Check the power plug and verify that the DES-3216 is receiving adequate power. Log in to the DES-3216 using Local Console Management, see Chapter 5, Managing the DES-3216, for instructions.

Power the DES-3216 off and then power it on again. Use the monitor to check the error messages. Return the DES-3216 to D-Link for service if the problem persists.

Forget Password If you forget your password, contact D-Link Technical Support at

(949)788-0805 for assistance or check our web site at www.dlink.com.

Troubleshooting

56

Image 64

Contents DES-3216 10/100 Auto Negotiation Switch User’s Guide Link Limited Warranty Hardware North, Central, and South America FCC Warning Wichtige Sicherheitshinweise Table of Contents Page Page Audience About This GuideOrganization Features IntroductionFront Panel Rear PanelManagement Methods Updating FirmwareLocal Console Management Telnet ManagementInstallation Options Installing the DES-3216Desktop/ Shelf Installation Power On Rack InstallationConnecting the DES-3216 to the Network Cable SpecificationsCable Diagram Connecting the DES-3216 to the DES-5024 and Hubs PortsDES-3216 to DES-3216 Connection MDI-X PortLQN LEDsPower LED DES-3216 LED PanelLED Managing the DES-3216 Local Console ManagementTelnet ∙ Data bits ∙ Parity None ∙ Stop bits ∙ Flow Control None∙ Default User Name D-Link ∙ Default Password D-Link LogHelp Message Help MessagePanel Conventions SpacebarSystem Configuration Switch Port 1-8, 9-16 ConfigurationSpanning Tree Configuration Console ProgramVlan Port Management Snmp Management ConfigurationTrunking Port Management System Configuration Menu System ResetFactory Reset to Default Config Values System InformationSoftware Update Boot Prom Firmware VersionSystem Information Menu Hardware RevisionLAN Default Gateway Software VersionMAC Address System DescriptionSystem Reset System ResetFactory Reset Factory ResetFactory Reset Confirmation Advantages of Store and Forward System Rate ControlDisadvantages of Store and Forward Advantages of Cut-Through Disadvantages of Cut-ThroughSoftware Update Menu Software UpdateSoftware Update Transfer File Transfer through Xmodem User Account Change Menu User Account ManagementCreate New User Password Confirm PasswordAccess Level User NameStatus Delete UsersDelete Change Password Change PasswordOld Password New PasswordSwitch Port Configuration State Switch Port Configuration MenuPhysical Port State PrioritySpanning Tree Configuration Spanning Tree Configuration MenuSTA Operation Levels Spanning Tree AlgorithmForward Delay Time Bridge PriorityRoot Cost Hello TimeRoot Port User Selective STA parametersSnmp Management Configuration Snmp Management Configuration MenuAccess Right Snmp Manager SettingSnmp Community String Snmp Trap Manager Setting Authentication FailureCold Start Link Change EventPage Vlan Port Management Vlan Port Management MenuVlan Port Management menu Create New Vlan New Vlan NamePort # TrunkGroupDelete Vlan Menu Vlan NameModify Vlan Menu Virtual LAN NameTrunking Port Management Menu Trunking Port Management menuNew Trunking Group Name Create New Trunking PortName Delete Trunking Port Trunking PortModify Trunking Port Trunking Port NameTroubleshooting Problem SolutionPage Switch Specifications Appendix a DES-3216 Technical SpecificationsPort Specifications 10/100 Auto Negotiation Switch Users’ Guide General EMI 10/100 Auto Negotiation Switch Users’ Guide Performance Access Level IndexUser Name 32, 33