D-Link DES-1004 manual Rack Installation DES-1008

10/100 Fast Ethernet Switch User’s Guide

♦Drill two holes into the wall with the same distance as the screw support holes located on the bottom of the Switch. Do not drill these holes too deep.

♦Insert the plastic anchors into the holes in the wall and secure them with gentle taps of a hammer.

♦Screw in the screws provided with the wall mount kit into the plastic anchors. Do not insert the screws with excessive torque. Note that the screw’s head along with a small portion of the screw’s body should be sticking out.

♦Gently, place the Switch onto the wall with the front panel facing up or down by sliding the screws into the provided slots.

♦Make all power and network connections at this time, see Connecting the Switch.

Rack Installation (DES-1008)

The DES-1008 can be mounted in an EIA standard size, 19-inch rack, which can be placed in a wiring closet with other equipment. The mounting

brackets for the DES-1008 are an optional item and must be purchased separately from your local re-seller. To install, attach the mounting

brackets on the switch’s front panel (one on each side) and secure them with the screws provided.

Unpacking and Setup 9