D-Link DES-1004 manual 10Base-T Hub, 100Base-TX Hub

Page 30

10/100 Fast Ethernet Switch User’s Guide

Figure 10 DES-1008 Switch connected to a 10 or 100Base-TX Hub

10Base-T Hub

For a 10 Base-T hub, the Switch’s LED indicators should illuminate the following:

♦100M LED speed indicator is OFF.

♦Link/Act indicator is ON.

♦FDX/Col indicator is OFF.

100Base-TX Hub

For a 100Base-TX hub, the Switch’s LED indicators should illuminate the following:

♦100M LED speed indicator is ON.

♦Link/Act is ON.

♦FDX/Col LED indicator is OFF.

20	Connecting The Switch

Image 30

Contents DES-1004/ DES-1008 10/100 Fast Ethernet Switch User’s Guide Wichtige Sicherheitshinweise Warranties Exclusive Limited Warranty Software Trademarks Table of Contents Viii About this Guide PurposeTerms/Usage Overview of this User’s Guide Introduction Fast Ethernet TechnologySwitching Technology Features Performance features Introduction Unpacking and Setup UnpackingSetup Desktop or Shelf InstallationWall Installation DES-1004 10/100 Fast Ethernet Switch installed on a Desktop or ShelfRack Installation DES-1008 Installing the DES-1008 Switch in an equipment rack DES-1004 Power onLED Indicators DES-1008Power Failure Identifying External Components Front PanelRear Panel DES-1008 Cable OrganizerRear panel view of the DES-1004 switch LED Indicators DES-1004 Switch LED indicatorsIdentifying External Components Connecting the Switch PC to SwitchHub to Switch DES-1008 Switch connected to a PC or Workstation10Base-T Hub 100Base-TX HubUsing straight cable Using crossover cableHub without Uplink MDI-II port Switch to Switch other devices Connecting The Switch Page Technical Specifications GeneralPhysical and Environmental Performance Specification RJ-45 PINStandard Category 3 cable, RJ-45 pin assignment Index Switching LAN technology Switching Technology Page Offices Page Registration Card