D-Link DES-1004 manual Connecting the Switch, PC to Switch

Page 28

10/100 Fast Ethernet Switch User’s Guide

4

4CONNECTING THE SWITCH

This chapter describes how to connect the DES-1004/ DES-1008 to your Fast Ethernet network. In each of the following figures, the DES-1008 is shown; however, similar cable connections can be attained on the DES-1004 because of product similarities.

PC to Switch

A PC can be connected to the Switch via a two-pair Category 3, 4, 5 UTP /STP straight cable. The PC (equipped with a RJ-45 10/100 Mbps jack) should be connected to any of the four ports (1x -4x) for the DES-1004 or eight ports (1x - 8x) for the DES-1008.

18	Connecting The Switch

Image 28

Contents DES-1004/ DES-1008 10/100 Fast Ethernet Switch User’s Guide Wichtige Sicherheitshinweise Warranties Exclusive Limited Warranty Software Trademarks Table of Contents Viii Purpose About this GuideTerms/Usage Overview of this User’s Guide Introduction Fast Ethernet TechnologySwitching Technology Features Performance features Introduction Unpacking and Setup UnpackingSetup Desktop or Shelf InstallationWall Installation DES-1004 10/100 Fast Ethernet Switch installed on a Desktop or ShelfRack Installation DES-1008 Installing the DES-1008 Switch in an equipment rack Power on LED IndicatorsDES-1004 DES-1008Power Failure Identifying External Components Front PanelRear Panel DES-1008 Cable OrganizerRear panel view of the DES-1004 switch LED Indicators DES-1004 Switch LED indicatorsIdentifying External Components Connecting the Switch PC to SwitchHub to Switch DES-1008 Switch connected to a PC or Workstation10Base-T Hub 100Base-TX HubUsing crossover cable Using straight cableHub without Uplink MDI-II port Switch to Switch other devices Connecting The Switch Page Technical Specifications GeneralPhysical and Environmental Performance Specification RJ-45 PINStandard Category 3 cable, RJ-45 pin assignment Index Switching LAN technology Switching Technology Page Offices Page Registration Card