Altinex MT110-100/102 manual Precautions / Safety Warnings, General, Installation, Cleaning

Page 3

MULTITASKER™

PRECAUTIONS / SAFETY WARNINGS

1

Please read this manual carefully before using your MT110-100/102. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your MT110-100/102and to prevent fire and shock hazard. Please read them carefully and heed all warnings.

1.1 GENERAL

Qualified ALTINEX service personnel, or their authorized representatives must perform all service.

1.2 INSTALLATION

To prevent fire or shock, do not expose this unit to rain or moisture. Do not place the MT110-100/102in direct sunlight, near heaters or heat radiating appliances, or near any liquid. Exposure to direct sunlight, smoke, or steam can harm internal components

Handle the MT110-100/102carefully. Dropping or jarring can damage the card.

Do not pull the cables that are attached to the MT110-100/102.

Insert the card carefully into the slots of the Multi-Tasker™ without bending any edges.

1.3 CLEANING

Clean only the connector area with a dry cloth. Never use strong detergents or solvents, such as alcohol or thinner. Do not use a wet cloth or water to clean the card. Do not clean or touch any component or PCB.

1.4 FCC / CE NOTICE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their expense.

Any changes or modifications to the unit not expressly approved by ALTINEX, Inc. could void the user’s authority to operate the equipment.

400-0132-005

2

Image 3
Contents MT110-100/102 Table of Contents General Precautions / Safety WarningsInstallation CleaningMT110-100/102 Technical SpecificationsDescription of MT110-100/102 Diagram 1 Typical Setup Application DiagramMultitasker Diagram 2 Internal View MT110-100 SwitcherMatrix Diagram 3 Internal View MT110-102 RS-232 Control Installing Your MT110-100/102Description of Commands OperationCnS ConfigurationConnection Output Volume VERSaved Group Operation STA1STA0 MT110-102 cardSingle Card Operation Path OperationFeedback Operation OFF12. …P Path SW Switch10. …S Save 11. …F FeedbackFBD CLROSI OSOSID+ RSISIDn SIDnCiRMG RSN25. WR RMCTest Remove ALL GroupsG1-G8EMPTY 28. RDVolume Ramping Feature MT110-102 only RDN MT110-102 only Ramp Time = 16 Seconds Ramptime = 6 SecondsMATmXy 16 xHelp OSO OFFCLR OSINo Sound Troubleshooting GuideLED is not LIT LED is Blinking REDSound Level is LOW Limited WARRANTY/RETURN PolicyAltinex Policy Distorted Sound