6.[…S] – Save
This command will save the configuration command being sent in memory. When sending the command [ON1C4S], after reset or power up, output 1 on C4 will be enabled.
7.[…F] – Feedback
After processing a command, an OK or ER will be returned as feedback if "F" is included at the end of a command string.
8.[…P] – Path
This command will set the path for the output, but it is not active until the switch command, [SW], is executed. Commands ending in "P" are not executed immediately. The path for outputs on multiple cards or the same card can be loaded. See examples in ON and OFF commands.
9.[SW] – Switch
The switch command immediately connects inputs and outputs, which were previously set with the path command. This command effects this card and all other cards in the
Example:
[ON1C6U3P]
[ON3C7U3P]
[SW]
The system will return feedback as OK if the unit ID is zero.
Command Format: [HELPCnUi]
Cn = card ID number (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9) ( refer to the
10.[HELP]
This command displays information available for the
Example:
In order to view the
commands along with a brief description will be displayed in the Terminal Window
11. [WR]
This command groups multiple cards in the Enclosure. Each unit contains a maximum of nine groups.
Command Format: [WRCn…GkUi]
Cn | = card ID (n = slot # from 1 to max slots) |
Gk | = group number (k = # from |
Ui | = unit number (i = # from |
Example:
To group cards #1, 2, and 3 as group 5 of unit #1, send the command [WRC1C2C3G5U1]. After executing this command, cards 1, 2 and 3 will be grouped together as group 5 of unit 1.
12. [CLR]
This command clears the members for a single group or for all nine groups.
Command Format: [CLRGkUi]
Gk | = group number (k = # from |
Ui | = unit number (i = # from |
Example:
1)To clear group #1, send the [CLRG1U1] command. This command clears the members for the specified group only.
2)To clear all groups of unit 1, send the [CLRG[U1] command.
13.[G]
This command is used to request group data. With the command, the user can identify which input or output of a particular group is on.
Command Format: [GkUi]
Gk | = group number (k = # from |
Ui | = unit number (i = # from |
Example:
In unit ID0, if group 1 has DA Cards with outputs 1 and 2 on, while group 2 has SW Cards with input 2 on:
9