American Power Conversion Automatic Disconnect Switch user manual Cable Modem Connection

Page 10

Installation

Cable Modem Connection



The cable modem utility power, F-connector, and USB connectors are located on the back of the cable modem.

Secure the appropriate cables to these connectors before installing the cable modem in the enclosure.



USB Cable

Tie Wrap Lance

F Connector

USB

Connector

Lo cal Po w er

Cable Modem

Rem ot e P o wer

 

 

Utility Power

 

IEC Recepticle

Connect the appropriate cables to the cable modem IEC receptacle, the USB port, and the F-connector located on inside the enclosure.

Using the lance on the enclosure secure a tie wrap to the USB cable if required.

10

Broadband Automatic Disconnect Switch User Manual

Page 9 Page 11
Image 10
Page 9 Page 11
Contents
Broadband Automatic Disconnect Switch Page Introduction SafetySpecifications About this unitInstallation UnpackSchematic Overview of the Automatic Disconnect Switch System Mount the Automatic Disconnect Switch on the Wall Utility Power ConnectionsHardwire the Automatic Disconnect Switch Connector Installation Cable System ConnectionsCoax Connection   Cable Modem Connection Operation Indicators and ControlsPrimary/Secondary Access Panel Start UpPrimary Status Cable ModemSecondary Status Limited Warranty Problem and/or Possible Cause SolutionService FCC Compliance Notice
Related manuals
Manual 14 pages 29.01 Kb