Installation
Hardwire the Automatic Disconnect Switch
Step |
•Remove the utility wiring panel located on top of unit.
• When required apply a strain relief grommet to the utility wiring panel holes.
Step |
•Route the building wiring through the holes in the utility wiring panel.
•Connect the 220 V building wiring to the Input
Hardwire terminal block.
Step
•Route the input wiring for the FRP/FLM through the
hole in the utility wiring panel.
• Connect the FRP/FLM input wiring to the Output Hardwire terminal block.
Step |
Reinstall the utility wiring panel. Secure the panel with the screw removed in Step .
Broadband Automatic Disconnect Switch User Manual | 7 |