6 | Patch Release Note |
•The PORT parameter of the SET STP PORT command specifies either all the ports in a trunk group, or none of the ports in a trunk group.
•The STPFORWARD parameter has been added to the ENABLE SWITCH and DISABLE SWITCH commands. If STPFORWARD is enabled, and there is no enabled STP instance, then the switch will forward all received BPDUs. If STPFORWARD is enabled, and an STP instance is enabled, then STPFORWARD will be disabled by default and a message will be generated.
•The SHOW SWITCH command now shows the status of the BPDU Forwarding feature.
PCR: 03401 | Module: SWI |
An enhancement has been made to the Test module to optimise the reception of the loopbacked packets that are used to confirm operation of the switch ports.
Features in SB251-06
Patch file details are listed in Table 5.
Table 5: Patch file details for Patch
Base Software Release File | |
|
|
Patch Release Date | |
|
|
Compressed Patch File Name | |
|
|
Compressed Patch File Size | 79684 bytes |
|
|
Patch
PCR: 03340 | Module: SWI, SYSR | Level: 1 |
After a power cycle, or a reboot command, the SwitchBlade would occasionally repeatedly restart if it had two active controller cards. Also, the Slave controller card would sometimes not take over if the Master controller card failed.
Features in SB251-05
Patch file details are listed in Table 6.
Table 6: Patch file details for Patch
Base Software Release File | |
|
|
Patch Release Date | |
|
|
Compressed Patch File Name | |
|
|
Compressed Patch File Size | 71096 bytes |
|
|
Patch