Patch | 11 |
The DPORT parameter in the ADD SWITCH HWFILTER command was omitted when the configuration was generated. This issue has been resolved.
PCR: 03023 | Module: SWI | Network affecting: No |
The SET SWITCH PORT ACCEPTABLE command did not work correctly on all specified port numbers. This issue has been resolved.
PCR: 03028 | Module: SWI | Network affecting: No |
A warning message was generated when a slave line card was not initialised, and the configuration script was not loaded. This issue has been resolved.
PCR: 03030 | Module: SWI | Network affecting: No |
RIP was not operating correctly because a MAC address search returned the wrong port number. This issue has been resolved.
PCR: 03031 | Module: FIREWALL | Network affecting: No |
The ADD FIREWALL POLICY RULE command included an erroneous check on port ranges for
PCR: 03034 | Module: SWI | Network affecting: No |
Executing the SET IP INTERFACE and SET IPX INTERFACE commands on a SwitchBlade produced debugging output on the ASYN port. This issue has been resolved.
PCR: 03037 | Module: QOS | Network affecting: No |
A new value is now shown in the output of the SHOW QOS POLICY command. This is the value of the port bandwidth used when the default traffic class percentage bandwidth is set on a QoS Policy.
PCR: 03039 | Module: SWITCH, IPG | Network affecting: No |
Adding a layer 2 filter on a SwitchBlade did not block traffic to the end host as intended. This issue has been resolved.
PCR: 03043 | Module: SWITCH | Network affecting: No |
On a SwitchBlade, PCI errors occurred periodically after a line card was hotswapped. This issue has been resolved.
PCR: 03047 Module: CORE | Network affecting: No |
The board revision number for the slave control blade was erroneously set to the same number as the master control blade. This issue has been resolved.
PCR: 03428 | Module: STP | Network affecting: No |
If a port belongs to an enabled STP instance, but the port has been disabled from STP operation with the DISABLE STP PORT command, the port will not respond to ARP requests. This patch implements a workaround that allows disabled STP ports to respond to ARP requests.
Patch