How to Start an AT-GS950/8 WEB Management Session
System Default Gateway - Displays the default gateway of the switch. To change the default gateway, enter a new gateway. When DHCP is enabled, you cannot change this parameter.
DHCP Mode - For information about setting this parameter, refer to “DHCP Client Configuration” on page 18.
4. Click Apply.
Note
Changing the IP address ends your management session. To resume managing the device, enter the new IP address of the switch in the web browser’s URL field, as shown in Figure 1 on page 4.
5.After you log on to the switch with the new IP address, select Save Configuration to Flash from the main menu on the left side of the page to save the new IP address to memory.
Caution
If you do not select Save Configuration to Flash, the IP address will revert to its original setting when you power cycle or reboot the switch.
10