How to Start an AT-GS950/8 WEB Management Session
Enabling Factory Default Reset
If the Factory Default Reset feature is disabled and you choose to Enable it, perform the following procedure:
1.From the main menu on the left side of the page, select the Tools folder.
The Tools folder expands.
2.From the Tools folder, select Reboot.
The Factory Default Reset/Reboot Page is displayed. See Figure 16.
3.Go to the Factory Default Reset section on the upper part of the page. The Factory Default Reset field should be set to Disable.
Note
If the Factory Default Reset field is already set to Enable, you do not need to continue with this procedure.
4.To enable the factory default reset feature, select Enable on the pull- down menu of the Factory Default Reset field.
The Factory Default Reset/Reboot Page changes to include a Password field for entering a password. See Figure 17 on page 36.
Figure 17. Factory Default Reset/Reboot Page with Password Entry
5.Enter the same password that you defined when you previously set the Factory Default Reset field to Disable.
6.Click Apply.
The initial Factory Default Reset/Reboot Page is displayed with the Factory Default Reset field Enabled. See Figure 14 on page 32.
In the Reboot section, the Reboot Type field now includes the options presented in its pull down menu for returning the switch configuration to the factory default values. See “Configure Factory Default Values” on page 32 for more information.
7.From the main menu on the left side of the page, select Save Configuration to Flash to permanently save your changes.
36