Allied Telesis manual How to Start an AT-GS950/8 WEB Management Session

How to Start an AT-GS950/8 WEB Management Session

Caution

Since you define this password as part of the process of disabling this function, Allied Telesis has no knowledge of it. You are responsible for keeping the password in a safe place. If it is lost, Allied Telesis does not have a way to help you recover it.

See “Disabling Factory Default Reset Feature” on page 34 for information about how to disable the factory default reset feature.

Switch Reboot The following procedure outlines how to reboot your AT-GS950/8 switch.

Caution

This procedure reboots the switch and reloads the AT-S107 Management software configuration from flash memory. Insure that your current configuration is saved before rebooting the switch by selecting Save Configuration to Flash from the main menu on the left side of the page to permanently save your changes.

All configuration parameters that have not been previously saved are lost. After the switch is reboots, they are reset to the values stored in the flash memory.

Caution

This procedure causes the switch to reboot. The switch does not forward network traffic during the reboot process. Some network traffic may be lost.

1.From the main menu on the left side of the page, select the Tools folder.

The Tools folder expands.

2.From the Tools folder, select Reboot.

The Factory Default Reset/Reboot Page is displayed. See Figure 14.

31