Control console

MAC address of 00 c0 b7 63 9f 67, use one of the following commands:

–Windows®command format:

arp -s 156.205.14.141 00-c0-b7-63-9f-67

–LINUX command format:

arp -s 156.205.14.141 00:c0:b7:63:9f:67

For the MAC address, look on the bottom of the Main Module or on the Quality Assurance slip included in the package.

2 . Use Ping with a size of 113 bytes to assign the IP address defined by the ARP command. For example:

–Windows command format:

ping 156.205.14.141 -l 113

–LINUX command format:

ping 156.205.14.141 -s 113

3 . Use Telnet to access the Main Module at its newly assigned IP address. For example:

telnet 156.205.14.141

4 . Use apc for both User Name and Password.

5 . See “Control console” on this page to finish the configuration.

After you log on at the control console, as described in “Local access to the control console” on page 18 or “Remote access to the control console” on page 18:

1 . Choose Network from the Control Console menu.

2 . Choose TCP/IP from the Network menu.

3 . If you are not using a BOOTP or DHCP server to configure the TCP/IP settings, select the Boot Mode menu. Select Manual boot mode, and then press ENTER to return to the TCP/IP menu. (Changes will take effect when you log out.)

4 . Set the System IP, Subnet Mask, and Default Gateway address values.

5 . Press CTRL+C to exit to the Control Console menu.

6 . Log out (option 4 in the Control Console menu).

Note: If you disconnected a cable during the procedure described in “Local access to the control console” on page 18, reconnect that cable and restart the associated service.

Environmental Manager: Main Module