APC AP9340 manual To install sensors in another location

6 . To secure the sensor cord, choose a location near the middle of the door frame, and repeat step 5.

Note: If you use more than one sensor per rack, route the sensor cord farthest from the middle of the rack first. When routing the sensor cord closest to the middle of the rack, secure all sensor cords in the tie wrap.

7 . With the door fully open, thread the sensor cords through the opening in the front post of the rack.

aem0076a

8 . Route the cords between the vertical support rail and the side panel. Each 4-m (13-ft) sensor cord may be extended to a maximum of 15 m (50 ft), using RJ-45 couplings and standard CAT5 cables.

To install sensors in another location:

1 . Use one of the following methods, depending on the type of surface on which you are mounting the sensor:

–To mount the sensor on a wall or other smooth surface, peel the backing off the adhesive of the sensor mount, and place the sensor mount onto the wall.

–To mount the sensor on a rough wall or porous surface, first install the wall anchor. Then attach the adhesive sensor mount to the wall anchor using the provided flat-head screw.

2 . Thread a tie wrap through the sensor mount, and secure the sensor with the tie. Tighten the tie wrap and trim any excess.

3 . Neatly route the sensor cord and connect the sensor to the APC device.

12 Environmental Manager: Main Module