Linksys EF1324 manual Network Configuration, IP Configuration

Page 13

Instant EtherFast® Series

Network Configuration

The Network Configuration menu allows you to set the Switch’s IP address, configure the IP parameters, or enable the on-board Web management.

•IP Configuration* - Sets the bootup option or configure the Switch’s IP parameters. It changes the default IP address on the Switch.

•IP Connectivity Test (Ping) - Tests IP connectivity to a specified device. You can plug in a workstation on the network to check for connectivity.

•HTTP Configuration - Allows the admin to enable or disable the Web administration feature of the Switch.

*This menu does not appear if the Switch is set to multilayer mode. In this case, you need to configure an IP interface for each VLAN that needs to con- nect to any device outside of its own VLAN group.

Select OK to return to the previous panel.

EtherFast® Layer 3 Management 24-Port 10/100 + 2-Port Gigabit Ethernet Switch

IP Configuration

The IP Configuration menu allows you to configure the IP parameters. (Only displayed in Layer 2 mode)

•Interface Type - Indicates IP over Ethernet.

•IP Address - IP address of the Switch you are managing. The system supports SNMP over TCP/IP transport protocol. In this environment, all systems on the Internet, such as network interconnection devices, must have an IP address.

•Subnet Mask - Subnet mask of the Switch. This mask identifies the host address bits used for routing to specific subnets.

•Gateway IP - Gateway used to pass trap messages from the system to the management station. Note: The gateway must be defined (when oper- ating at Layer 2) if the management station is located in a different IP segment.

•IP State - Specifies whether IP functionality is enabled via manual con- figuration (default setting), or set by Boot Protocol (BOOTP).

Select Apply to make changes. Select OK to return to the previous panel. Select Cancel to cancel any changes.

18

19

Image 13

Contents User Guide Copyright & Trademarks Table of Contents Introduction LEDs Getting to Know the SwitchPre-Installation Considerations Installing the SwitchRJ-45 Ports Gigabit PortsRack-Mounting the Switch Switch ManagementPowering on the Switch Uplinking the SwitchWeb Management Telnet Management Connecting the Serial Cable to the Switch and ComputerLogging On to the Switch Configuring the Switch Using the Console InterfaceOverview Main MenuSystem Information System Information MenuManagement Setup Menu Switch InformationIP Configuration Network ConfigurationIP Connectivity Test Ping Http ConfigurationSnmp Configuration Serial Port ConfigurationIP Trap Managers Snmp CommunitiesAdd User User ConfigurationTftp Download Configuration FileDevice Control Menu Management Access ControlSystem Mode Layer 2 Menu Port ConfigurationPort Trunking Configuration Mirror Port ConfigurationAdd Static Address Entry Static Unicast Address ConfigurationApply Add Multicast Address Entry Static Multicast Address ConfigurationBridge Menu Bridge ConfigurationVlan Menu Spanning Tree Port ConfigurationVlan and Priority Vlan Port ConfigurationIP Menu Vlan Table ConfigurationModify Subnet Subnet ConfigurationSubnet Configuration Modify Ospf Configuration Subnet Configuration Modify RIP ConfigurationSubnet Configuration Modify Dvmrp Configuration Add Subnet Protocol ConfigurationRIP Configuration ARP ConfigurationOspf Configuration Menu Ospf Area Configuration Add Ospf Area IP Menu Ospf Area ConfigurationAdd Ospf Range Ospf Area Range ConfigurationAdd Ospf Virtual Link Ospf Virtual Link ConfigurationAdd Ospf Host Route Ospf Host Route ConfigurationAdd Bootp Relay Server Bootp Relay Database ConfigurationIgmp Snooping Configuration Add Static ARP Entry Static ARP TableAdd Routing Entry Static Route TableSecurity Menu Default Route MenuSecurity Mode MAC Filtering ConfigurationAdd MAC Address Filter Igmp Snooping Configuration IP Security Filtering ConfigurationAdd IP Address Filter Port Statistics/Statistics Menu Network Monitor MenuInterfaces Port StatisticsEthernet Rmon Statistics Layer 2 Address Table Spanning Tree Bridge Information Spanning Tree Port Information Vlan Dynamic Registration Information Vlan InformationIP Multicast Registration Table Vlan Forwarding InformationSubnet Information Routing Table ARP TableIgmp Cache Multicast Table MenuMulticast Forwarding Cache Dvmrp Neighbor Table Dvmrp Routing TableOspf Interface Table Ospf Table MenuOspf Neighbor Table Ospf Link State TableSystem Restart Menu Ospf Virtual Neighbor TableCommon Problems and Solutions TroubleshootingExit Appendix Your firmware has now been updatedUpgrading Firmware via the Serial Port Glossary 121 123 Environmental SpecificationsTechnical Support RMA Issues Fax Warranty InformationContact Information Sales InformationT p / / w w w. l i n k s y s . c o m