1:N Verification (“One to Many” Verification)
In this mode, a user simply takes a fingerprint reading. The TQ600 compares their fingerprint to all of the fingerprint templates stored in the terminal. 1:N verification takes more time than 1:1 verification. The verification time is dependent on the number of fingerprint templates stored in the terminal.
1) Place finger on the sensor surface, the following appears:
FP Verify
Remove Finger
2)It continues for about 0.5 seconds. If the test is successful, the following appears:
Verify
User ID 00001
Verified.
3)If your identity cannot be verified, you are prompted to try again, the following appears:
FP Verify
Please Try Agn.
It continues for about 0.5 seconds, return to the
- 26 -