SuperSmart User’s Guide
TROUBLESHOOTING If the Link/Traffic LED does not light up when a device is connected to its corresponding port, check that both the hub and connected device are powered on. For devices connected to the hub using a
Traffic
Traffic refers to the movement of packets being received by the port. A port’s corresponding Link/Traffic LED will blink (ON) in proportion to the rate of traffic passing through the port.
Through this LED, the network manager can easily view the activity on a port.
Diagnostic Test LED Indicators
The
LED Activity | Condition |
BLINKING RED LIGHT | ON |
|
|
NO LIGHT | OFF |
|
|
Indication
The corresponding hardware component failed the diagnostic test.
The corresponding hardware component successfully passed the diagnostic test.
After power on, the hub automatically performs a diagnostic test. Seven hardware components are tested for SuperSmart hub. During this test, Partition LEDs indicate the success/failure of each test. The following table shows what each Partition LED monitors.
Partition LED Indicator
1
2
3
4
5
6
7
Test function/component
CPU
ROM
RAM
Serial communication controller
Hub control 1
Hub control 2
Timer
Hardware Description |