SuperSmart User’s Guide
Using the Configure Button
There are 5 configuration functions accessed in sequence using the Configure button, including:
∙Segment Setting
∙Demo Function
∙Diagnostic Function
∙Reset Function.
A "long press" on the button allows you to switch from one function to the next. While a "short press" switches between selections within each function. LED indicators light up to indicate which configuration function the system is in.
Before using the Configure button, remember that:
∙A "long press" means pressing the Configure button for more than 2 seconds and then releasing the button. While a "short press" means pressing the Configure button and immediately releasing it.
∙A "long press" has 2 functions. (1) It works like an [Enter] key ⎯ implementing the last selection displayed by the LED
indicators for the current function. (2) It brings the system to the next configuration function.
∙A "short press" is used to switch between the selections available within each function. For example, in Segment Setting, there are 4 selections available. By using a "short press" on the Configure button, you can move from one selection (e.g., Attach hub to Segment 1) to the next (e.g., Attach hub to Segment 2). Note, however, that a selection will only take effect after a "long press" on the Configure button.
∙If the button is not pressed within 10 seconds, the system returns to normal operation effecting all changes made prior to selecting the current function.
Setup and Configuration |