SuperSmart User’s Guide
The system tests each component one at a time. The unit will complete the test cycle even if a problem is detected on any of the components. If no lights are ON, this means that all the hub components passed the diagnostics. If any problems were detected, the corresponding LED will blink after test completion to indicate which component failed the test.
Configure Button
On the left front panel is a button labeled Configure. Use this button for the following configuration functions:
∙Segment Setting
∙Demo (LED display demonstration)
∙Diagnostics
∙Reset
Move from one function to the next by using a "long press" on the button. LED indicators will light up depending on the selected system function. Make necessary choices within the current function using a "short press". Then, use a "long press" to effect your choice and move on to the next function. See Using the Configure Button in Chapter 4 for related information.
Φ"Long press" in this User’s Guide means pressing the Configure button for more than 2 seconds and then releasing it. "Short press" means pressing the Configure button and immediately releasing it. Also, if the button is not pressed within 10 seconds, the system returns to normal operation.
Hardware Description |