Adder Technology TS4 manual Keyboard and mouse connections, Remote control connections

Keyboard and mouse connections

To connect a keyboard and mouse

1At the rear panel of the Adder TS4 unit, attach the connector from the keyboard to the purple socket that is closest to the power input socket.

2At the rear panel of the Adder TS4 unit, attach the connector from the mouse to the green socket that is closest to the power input socket.

Remote control connections

The remote control unit can be used to provide manual switching between systems.

Note: The remote control cannot be used in conjunction with the Adder TS4 when a Synchrony auto switching link is being used because they both use the same switching socket.

To connect the remote control

1On the underside of the Adder TS4 unit, ensure that switch 5 is switched OFF. Note: The switch settings are consulted by the unit only during its power up phase, i.e. when power is first supplied by a keyboard socket of a powered system. Therefore, change the setting while the unit is disconnected or use switch 8 to force a reset, whereupon the other switches will be consulted.

2Locate the remote control unit and the remote control cable. Attach the smaller of the two cable connectors to the socket at the rear of the remote control.

  

Optional power supply connections

Note: The Adder TS4 can obtain its power from the keyboard connections of any of the four connected systems. Thus, an external power supply is not required unless the connection cables used exceed 2 metres.

Important: Please read and adhere to the electrical safety information given within the Safety information section of this guide. In particular, do not use an unearthed power socket or extension cable.

To connect the optional power supply

1Attach the output connector of the power supply (country specific power supplies are available) to the socket on the far left of the rear panel of the Adder TS4.

2When all other connections have been made, connect the main body of the power supply to a nearby earthed mains socket.

3At the other end of the cable, attach the larger connector to the socket on the end of the Adder TS4 unit.

 