Synchrony connections
When using the Synchrony software utility to provide automatic system switching (according to mouse movements) it is necessary to link the Adder TS4 to the designated ‘primary’ system that will run the software utility.
Note: The remote control cannot be used in conjunction with the Adder TS4 when a Synchrony auto switching link is being used because they both use the same switching socket.
To connect the Synchrony serial link cable
1Locate the Synchrony serial link cable.
2Attach the smaller of the two cable connectors to a vacant serial port socket on the designated ‘primary’ computer system (the system that will be running the Synchrony software utility).
Vacant serial port on designated primary system
3At the other end of the cable, attach the larger connector to the socket on the end of the Adder TS4 unit.
4On the underside of the Adder TS4 unit, remember to set switch 5 to ON to enable the auto switching mode.
|
| ON |
|
|
|
| Change switch 5 |
1 | 2 |
|
|
|
|
| to ON |
|
|
|
|
|
| ||
| 3 |
|
|
|
|
| |
|
| 4 |
|
|
|
| |
|
|
| 5 |
|
|
| |
|
|
|
| 6 |
|
| |
|
|
|
|
| 7 |
| |
|
|
|
|
|
| 8 | |
|
|
|
|
|
|
|
Notes:
•For more information about how the Synchrony system works, please refer to page 3.
•Ensure that the Synchrony utility on the Primary system operates in Server mode.
•Ensure that the Synchrony utilities on all of the other systems operate in
Client mode.