Adaptec SBC-596 manual Ethernet software configuration SBC-599 only

Ethernet software configuration (SBC-599 only)

The SBC-599 on-board Ethernet interface supports all major network operating systems. To configure the medium type, to view the current configuration, or to run diagnostics, do the following:

1.Power the SBC-599 on. Ensure that the RSET8029.EXE file is located in the working drive.

2.At the prompt type RSET8029.EXE and press <Enter>. The Ethernet configuration program will then be displayed.

3.This simple screen shows all the available options for the Ethernet interface. Just highlight the option you wish to change by using the Up and Down keys. To change a selected item, press <Enter>, and a screen will appear with the available options. Highlight your option and press <Enter>. Each highlighted option has a helpful message guide displayed at the bottom of the screen for additional information.

4.After you have made your selections and are sure this is the configuration you want, press ESC. A prompt will appear asking if you want to save the configuration. Press Y if you want to save.

The Ethernet Setup Menu also offers three very useful diagnostic functions. These are:

1.Run EEPROM test

2.Run Diagnostics on Board

3.Run Diagnostics on Network

Each option has its own display screen that shows the format and result of any diagnostic tests undertaken.

Chapter 3 Software Configuration 37