Parker Hannifin vm24 manual Jumper Configuration, VM24 Jumpers

Page 15

Jumper Configuration

The jumpers are used to configure the inputs for the I/O boards as sinking or sourcing. Each socket has its own corresponding jumper, allowing each board with inputs to be independently configured for sinking or sourcing.

Sinking Inputs:

Position 3 (shown)

 

Jumps pull-up to Vi (pin 3)

Sourcing Inputs:

Position 1

 

Jumps pull-up to Ground (pin 1)

The default jumper position when shipped from the factory is position 3, as shown below. The jumper positions only affect inputs on the VM24. Jumper position does not affect the outputs. Jumper position is irrelevant for SIM8-OUT boards.

JU1

Pin 3 = Vi

Pin 2 = Pull Up (connection to SIM socket)

1

Pin 1 = Ground

JU2

1

JU3

1

Figure 5: VM24 Jumpers

Installing the VM24 11

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Compumotor VM24 I/O Module N T E N T S Page Installation VM24-OUT What You Should Have Ship kitOverview VM24 Parameter Specification Specification SummaryOutputs T E Outputs are not short-circuit protected Environmental Description Boards Cable Type VM24 Assembly ConfigurationsVM24IN VM24OUT VM24S Pin Out TableElectrical Connections Power & Ground Screw TerminalsRight Side VM24 Jumpers Jumper ConfigurationRibbon Cable Connection Red Stripe Split Cable for the VM8/16 Input Connections SinkingSourcing VM24 Output ConnectionsVM24 Module Configuration Summary Page Troubleshooting Basic Troubleshooting Outputs Series Controller/IndexerVM24 Pin Ribbon CableSIM Board Insertion and Removal O Board and Socket To Insert I/O BoardsSIM Socket Clip Top View To Remove I/O BoardsVM24 I/O Module Pin Out Table
Top Page Image Contents