Parker Hannifin vm24 manual Output Connections, VM24

Output Connections

Caution

Remove power to the VM24 before

making any connections.

Connect the output pull-up pin OUT-P of the 6000 Series unit to Vo on the VM24 module to ensure the proper sequencing of output signals upon application of power to the VM24. The Output, Ground, and +5V connections between the 6000 Controller and the VM24 are made with the 50-pin ribbon cable to the J4 connector.

Use an external diode when driving inductive loads. Connect the diode in parallel to the inductive load, attaching the anode to the VM24 output and the cathode to the supply voltage of the inductive load.

Sinking

6000 Series

Controller

External Supply (up to 24VDC)

				+	–
		VM24		Vo
OUT-P
				(J6)
+5V	+5V			Ground (J6)
	(J4)			Connection
			Iso
Output				Output (J5)
			GND
Connection				Connection
	(J4)
Ground				Ground (J5)
				Connection
Connection
	(J4)
		Iso GND	Iso GND

Electronic

Device

Input

Sourcing

6000 Series

Controller

External Supply (up to 24VDC)

				+	–
		VM24		Vo
OUT-P
				(J6)
+5V	+5V			Ground (J6)
	(J4)			Connection
Output			Iso	Output (J5)
			GND
Connection				Connection
	(J4)
Ground				Ground (J5)
				Connection
Connection
	(J4)
		Iso GND	Iso GND

Electronic

Device

Input

Ground

Note: Make sure the jumper between OUT-P and +5V on the 6000 Series unit is removed to avoid damage to the VM24

16 VM24 I/O Module