Perreaux SXD2 owner manual Care and Maintenance

Page 19

7

Care and Maintenance

Note:

Cover

Front Panel

Note:

18

Please switch the unit off and remove the cord set from the rear of the USB DAC before attempting to clean your SXD2 in the manner described below.

Never apply liquid directly to the SXD2. Never use abrasives.

Never rub in a circular motion.

The cover features a durable high quality powder coat finish. To remove finger marks and dirt, lightly rub the surface with a soft cloth.

If the dirt is not removed, dip your cloth in a mild solution of soap and water, squeeze excess moisture from it and then gently reapply to the surface.

Stubborn dirt may be removed by the application of a small quantity of isopropyl alcohol, applied directly to the cleaning cloth only, and reworking the effected area.

The SXD2 front panel features a high quality electroplate finish. Over time the surface may retain finger marks and may need to be cleaned to restore it to original condition.

Regular Cleaning

Gently wipe the front panel with a very clean cotton cloth. Wipe across the surface and never in a circular motion.

Removing Stubborn Marks

Only attempt this infrequently, as too regular or vigorous application may damage the surface.

Apply a small quantity of any car polish containing carnauba wax to a very clean cotton cloth.

The car polish must state “Safe for Clear Coats” as the polish will therefore contain the absolute minimum amount of abrasive compound.

Gently wipe over the front panel in lateral motion, allow to dry then gently wipe off with a very clean cotton cloth.

Image 19
Contents Silhouette SXD2 Page This page has intentionally been left blank Perreaux Silhouette Series IntroducingKey Features Ii Important Safety Instructions Iii Table of Contents Unpacking and Placement Instant Install Congratulations Front Panel Functions Rear Panel Functions When operating the switch down, power is applied to the SXD2 Special Design Philosophies Minimalist Aesthetics Special Design Features Page Page Care and Maintenance Warranty Information Year Extended Warranty Form Extended WarrantyRegistration Form Troubleshooting Guide Interconnect cables damaged 6VRMS 11SpecificationsSignal to Noise Ratio 6VRMS Signal to Noise Ratio A-W eighted 113dB Physical Dimensions Contact Details Installation Notes