Perreaux SXD2 owner manual Troubleshooting Guide

Page 22

10

Troubleshooting Guide

There is no output from my system

Please use this guide if you are experiencing any problems with the SXD2 in your system. It will provide possible solutions for some given symptoms.

SXD2 not turned on

Make sure the SXD2 power switch is in the DOWN position.

AC cord not plugged in

Check that the AC cord is plugged into the IEC socket on the rear of the SXD2.

Mains power not turned on

Check if the power is turn on at the mains socket on the wall.

Interconnect cables not connected

Make sure that the interconnect cables are plugged in and connected to the respective sockets at the rear of the SXD2.

USB cable not connected

Confirm that the USB cable is plugged into both the computer and the SXD2.

USB/SPDIF switch on wrong setting

Select the correct input mode (USB or SPDIF) using the toggle switch on the rear of the SXD2.

Source not set to play

Ensure that your source component is playing the recording you would like to listen to, and that pause is not pressed.

Application software not properly configured

Make sure that the application software (eg. Winamp, iTunes) has been properly configured to use USB audio as its audio output device.

No volume setting

Make sure that the volume on your preamplifier is set to a suitable level.

SXD2 connected to incorrect input

Confirm that the output of your SXD2 is connected to the appropriate source input on your preamplifier.

21

Image 22
Contents Silhouette SXD2 Page This page has intentionally been left blank Introducing Perreaux Silhouette SeriesKey Features Ii Important Safety Instructions Iii Table of Contents Unpacking and Placement Instant Install Congratulations Front Panel Functions Rear Panel Functions When operating the switch down, power is applied to the SXD2 Special Design Philosophies Minimalist Aesthetics Special Design Features Page Page Care and Maintenance Warranty Information Year Extended Warranty Form Extended WarrantyRegistration Form Troubleshooting Guide Interconnect cables damaged 11Specifications 6VRMSSignal to Noise Ratio 6VRMS Signal to Noise Ratio A-W eighted 113dB Physical Dimensions Contact Details Installation Notes