Error | Description |
|
|
757 | Load supplies (supply length mismatch), |
Load Supplies | because the calibrated supply length |
| differs by plus or minus .25 inches from |
| the format. Press A under x to clear the |
| error. |
758 | Either the supply is not seen or the on- |
Check Supply | demand sensor is broken. Press A |
| under x to clear the error. Check for a |
| label jam, clear the supply path, or |
| reload supplies. This error may occur if |
| you remove a label too quickly in on- |
| demand mode. The printer does not |
| recalibrate after this error. |
762 | Recharge the battery. Press A under x |
Low Battery | to clear the error. |
763 | Waiting to dispense label. Press A |
Remove Label | under x to clear the error. |
765 | The printhead has less than four bad |
Check | dots. The printer can shift bar code |
Printhead | fields to avoid bad dots. Press A under |
| x to clear the error and continue printing. |
768 | Printhead has more than 10 bad dots or |
Check | is not connected. Connect the printhead. |
Printhead | Press A under x to clear the error. |
791 | The printer has an error pending. Turn |
Error Pending | off the printer. Wait 15 seconds and turn |
| it back on. Resend the packets. |
If you see a System Error Vector ## on the display, call Service for instructions. If you need to return the printer to Paxar, use the original packaging (box and packing material).