Paxar Sierra Sport2 manual Installing the Battery

Page 7

Installing the Battery

The battery can be installed with or without supplies loaded.

Note: Make sure the battery is charged before using it.

1.Turn off the printer if you are changing batteries.

2.Open the supply door by pushing down on the release buttons located on both sides of the printer. The supply door should swing open.

Release

Button

3.Insert the connector end of the battery into the printer.

Getting Started 1-3

Image 7

Contents Monarch Sierra Sport Printer Canadian D.O.C. Warning Getting Started B L E O F C O N T E N T SPrinter Options Additional Documentation T T I N G S TA R T E DIntroduction AudiencePrinter Utilities Unpacking the Printer About the Printer’s PowerInstalling the Battery Ready 4Getting Started Battery and Safety Information 6Getting Started Connecting the Communications Cable Plug the DB9 connector into the DB9 port Printing Using the Display and Buttons10Getting Started A D I N G S U P P L I E S Loading for Non-Peel Mode2Loading Supplies Tearing the Supplies Loading for Peel Mode Peel Bar Release Button Liner separates from the label I N T E N a N C E CleaningLay the printer on its back Printhead Clearing Label Jams Troubleshooting 2710 Common ErrorsError Description 4Troubleshooting E C I F I C AT I O N S Printer SpecificationsOperating Limits Cable Pin-outs Supply Specifications4Specifications C E S S O R I E S B Accessory Items Part NumberCarrying Accessories Single Station Battery ChargerFour Station Battery Charger AC Power AdapterI N T E R O P T I O N S C BluetoothLinerless 2Printer Options