Paxar 9855 RFID manual Platen Roller

4. Clean the platen roller when you see significant adhesive build-up or a label is wrapped around the platen roller. Use

adry, soft-bristle brush, such as a toothbrush, to clean the platen roller.

If the brush does not remove

all the adhesive, use isopropyl alcohol on the platen roller. Moisten a cotton

swab with isopropyl alcohol and run the cotton swab across the platen roller. Turn the platen roller with your finger to make sure the platen roller is clean all the way around. After cleaning, feed several inches of supply through

without printing to remove any remaining isopropyl alcohol.

Platen Roller

5. Rub the cotton swab moistened with isopropyl alcohol across the peel bar and remove any build-up.

6. Moisten another cotton swab with isopropyl alcohol. Rub the cotton swab across the printhead and remove any build-up. You may need to use a printhead CLEAN-STRIP if the printhead is extremely dirty or you see streaks on the supply.

Printhead

Supply

Sensor

7. Rub the cotton swab across the supply sensor and die cut sensor and remove any build-up.

8. Clean the build-up in the supply path.

9. Let the printer dry before you reload supplies.

13