R F I D S u p p l y S p e c i f i c a t i o n s
RFID supplies are available in a variety of sizes. Printing over the RFID inlay causes printing irregularity. Refer to the RFID Setup Guide & Supply Chart or the HF Setup Guide & Supply Chart for illustrations to determine which type of RFID supplies you are using and basic printer configuration information.
Supply Types: | Thermal Transfer or Thermal Direct |
| Die Cut or Black Mark |
Supply Widths: | 0.75 inch (19 mm) minimum |
| 4.0 inches (102 mm) maximum |
Supply Lengths: | 1.0 inch (25.4 mm) minimum |
| 13.0 inches (330 mm) maximum |
| Note: The supply length depends on the inlay selected. |
Roll Inside | 4.0 inches (102 mm) |
Diameter: |
|
Roll Outside | 8.0 inches (203 mm) maximum |
Diameter: |
|
Ribbon Width: | 4.3 inches (110 mm) for 4.0 inch (102 mm) supply |
Ribbon Length: | 23,600 inches (600 meters) |
Additional RFID supplies may be available by request. Contact your RFID Representative for more information.
T a g C u t D i m e n s i o n s
Use these specifications for the 926™ Knife with the RFMP printer. Use only Monarch→/Paxar→ approved RFID tag supplies.
Widths: | 1.5 | inches to 4.0 inches (38 mm to 102 mm) |
Lengths: | 1.5 | inches to 16.0 inches (38 mm to 406 mm) |
Thickness: | 7 mils to 14 mils | |
Batch Separator: | 3.66 inches (93 mm) | |
Note: The limited warranty on knives used in or with RFID printers is one (1) year from the date of shipment, or 500,000 cuts, whichever occurs first.
19