RuggedCom RX1501 manual Chassis Ground Connection, AC Power Supply Wiring Example

Page 23

3. Installation

3.2.3. Chassis Ground Connection

The RX1501 chassis ground connection, shown in Figure 3.12, “Chassis Ground Connection”, uses a #10-32 screw. It is recommended to terminate the ground connection in a #10 ring lug. Torque on the chassis ground connection should not exceed 30 in-lbs (3.4 Nm).

Figure 3.12. Chassis Ground Connection

3.2.4. AC Power Supply Wiring Example

Figure 3.13. Wiring for Single AC Power Supply (HIP module shown)

For 125/230VAC rated equipment, a appropriately rated AC circuit breaker must be installed.

It is recommended to provide a separate circuit breaker for each power supply module.

Equipment must be installed according to applicable local wiring codes.

RuggedCom® RuggedBackbone™

23

RX1501 Installation Guide Rev 104

Image 23
Contents RuggedBackbone RX1501 Registered Trademarks Warranty Contacting RuggedComAll Rights Reserved Disclaimer Of LiabilityTable of Contents Page List of Figures Page List of Tables FCC Statement And Cautions Functional Overview Feature HighlightsProduct Overview WAN Universal Power Supply Options LM1 through LM6 RuggedBackbone ModulesPM1 Front PanelModule Status LEDs Purpose DescriptionEthernet Fiber Line Modules LMEthernet Copper Cellular Modem SFP ModularWAN SerialAPE Appplication Processing Engine DDS Digital Data Services27. Pluggable terminal block power module HIP module shown Power SupplyRack Mounting InstallationRack Mounting Dimensions RX1501Rack Mounting Dimensions Top View Panel and DIN Rail Mounting Installing Panel and DIN Rail Mounting BracketsPanel and DIN Rail Mounting Dimensions Panel and DIN Rail Mounting DimensionsConnectors for 24, 24P, 48, and 48P Power Modules Power Supply Wiring and GroundingConnectors for HI and HIP Power Modules Chassis Ground Connection AC Power Supply Wiring ExampleDC Power Supply Wiring Example Critical Alarm WiringT1/E1 pinout Serial Console PortWAN Ports RJ45 DB9 PinGigabit Ethernet 1000Base-TX Cabling Recommendations WAN Ports BNCCopper Ethernet Ports 1. RJ45 Twisted-Pair Copper PortsCabling Category 1000Base Required Action Transient SuppressionRJ45 Pin Description Pin RS232 Mode RS485 Mode RS422 ModeSerial Ports RJ45 DDS Ports RJ45Tx LED Color Status SFP Optics Installation, removal, and precautionsDDS Rx and Tx LED Indications Rx LED Color StatusSFP Module Removal Module Insertion SFP25. SFP module removal Fiber Ethernet PortsModule Order Code Description Cellular ModemsGSM, EDGE, HSPA+ Cellular Modem Card Installing SIM Cards for GSM, EDGE, HSPA+ Cellular ModemsPage Supported Operating Systems Feature DescriptionAPE Application Processing Engine APE OverviewPlacing the APE in a Vlan Secondary Network InterfaceProcedure 3.1. To install an operating system Installing an Operating SystemLED Color and State APE BiosResetting the Module LED IndicatorsFAQs Copper Ethernet Port Specifications Technical SpecificationsPower Supply Specifications Critical Alarm Relay SpecificationsOrder Fiber Ethernet Port SpecificationsFast Ethernet 100Mbps Optical Specifications Cable Tx λ typ Tx min Tx max Distance PowerOperating Environment Mechanical SpecificationsGigabit Ethernet 1Gbps Optical Specifications ESD EMI And Environmental Type TestsTest Description Test Levels Severity Test Description Test Levels Ieee 1613 C37.90.x EMI Immunity Type TestsaAgency Standards Comments Agency ApprovalsRuggedCom Inc Warranty