3Com 7000HD manual ESD Safety Information

Page 10

1-2CHAPTER 1: INTRODUCTION

Special

Key

ESD Wrist

Strap

#1 Flat Head

Screwdriver

￿￿￿￿￿￿￿￿￿Installation Upgrade Kit

SafetyBefore working with any component in the CoreBuilder 7000

Precautions System, read and adhere to the following safety precautions.

ESD Safety Information

Electrostatic Discharge (ESD) can damage components on the system module. ESD, which occurs when the module or a component is improperly handled, can cause complete or intermittent failures.

CAUTION: To prevent ESD-related damage:

Always wear the ESD wrist strap supplied, ensuring that the strap is firmly secured to your wrist. The other end should be connected to a grounded surface Connect the clip on the end of the wrist strap to a grounding point on an anti-static table or to a grounded distribution rack.

Keep the 32MB Memory SIMM in its antistatic shielded bag until you

￿are ready to install it.

When working with CoreBuilder 7000 components, always place the component on the antistatic bag that it was shipped in.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents MB Memory Upgrade 3Com Corporation 5400 Bayfront Plaza Santa Clara, California Contents Page About this Guide Related ConventionsDocumentation User Guide Iv about this Guide Introduction InstallationUpgrade KIt GeneralESD Safety Information Information sur la prévention de décharges électrostatiques Sicherheitsinformationen für elektrostatische EntladungenUpgrade Simm 32MB Memory32MB Memory Upgrade Steps 32MB Memory UpgradeInstallation on ModuleLoosening the Captive Screws 32MB Memory Upgrade Steps Raise the key and slide the switch module out Figure Removing the 16MB Memory Simm Metal Spring Clip Side View of the Memory Simm Inserting the 32MB Memory Simm Cutout Inserting the 32MB Memory Simm Memory Upgrade Verifying 32MBPage Index NumbersVerifying memory upgrade Who should use this guide
Top Page Image Contents