3Com 7000HD manual Installation on, Module, 32MB Memory Upgrade Steps

Page 13

 

32MB MEMORY UPGRADE

2

INSTALLATION ON THE

 

COREBUILDER 7000HD SWITCH

 

MODULE

32MB Memory

Upgrade Steps

Step 1 Removing the CoreBuilder 7000HD Switch Module from the Chassis

Before starting, make sure that you wearing the ESD wrist strap and

that you are properly connected to grounding equipment as described in “Safety Precautions” on page 1-2.

Disconnect the cables from the module’s ports. Ensure that there is a record of where the cables are attached so that you can correctly

￿re-connect them to the module when finished.

With the #1 flathead screwdriver supplied, loosen the two captive screws located on the far left and right of the module near the ejector handles (Figure 2-1). Do not remove the screws.

Page 12 Page 14
Image 13
Page 12 Page 14
Contents MB Memory Upgrade 3Com Corporation 5400 Bayfront Plaza Santa Clara, California Contents Page About this Guide Related ConventionsDocumentation User Guide Iv about this Guide Upgrade KIt InstallationIntroduction GeneralESD Safety Information Sicherheitsinformationen für elektrostatische Entladungen Information sur la prévention de décharges électrostatiques32MB Memory Upgrade SimmInstallation on 32MB Memory Upgrade32MB Memory Upgrade Steps ModuleLoosening the Captive Screws 32MB Memory Upgrade Steps Raise the key and slide the switch module out Figure Removing the 16MB Memory Simm Metal Spring Clip Side View of the Memory Simm Inserting the 32MB Memory Simm Cutout Inserting the 32MB Memory Simm Verifying 32MB Memory UpgradePage Numbers IndexVerifying memory upgrade Who should use this guide
Top Page Image Contents